Highpower Security and Access Systems
800-991-3646  Facebook 203-634-3900 • sales@highpowersecurity.com
A New Level of Confidence
Door Access Controller

Highpower 3500 Door Control SystemNarrow mullion mounted door opener release.

Highpower Security's 3500 door access control system offers an array of features, and is available as a stand-alone product or part of a kit.

Basic features of the 3500 door access control system include one Wiegand card reader input, on-board Ethernet adaptor and a relay for controlling a locking device. Each 3500 access control unit is designed to control one door and can be distributed at each door of a facility. The 3500 is a small device housed in a stylish, plastic enclosure that has mounting slots that allow it to be surface mounted to a wall using two screws.

With this product you
might also need:
8000 Access Control Kit
access control kit

All the items needed for
card swipe 2-door
access control,
from cards to
controllers.

DS-1200 Magnetic
Lock Kit
magnetic lock kit

A complete magnetic
lock kit for one
door. Meets
NFPA
requirements.

Access Control Software
access control software

Highpower's
own
access
control
software.

JX Barcode & Magnetic Stripe Readers
barcode and magstipe Readers

Card swipe,
barcode and
prox readers
interfaced with
a panel or PC.

Need Advice?
Call us at 1-800-991-3646



3500 Door Access Control System Connections

Primary connections to the device are made at the bottom of the device by a removable terminal block. Secondary connections are made by connecting to either connectors or pin header. The removable terminal block has reader and relay connections and also provides two inputs, one for door position switch monitoring and a second for request to exit push buttons. The 3500's expansion port allows for connection to an LCD display (SPI clocked data port) and additional I/O for custom applications.



Powering the 3500

The 3500 door access control unit is powered by a 12VDC plug in wall transformer that connects to a barrel jack at the bottom of the unit. Two indication LEDs, one that shows data activity and one that works as a power/relay state indication light are also present at the bottom connection panel. There is a configuration jumper inside the device that can be set to route power from the plug-in transformer to the relay terminals. A reset switch can be depressed with the end of a paper clip, located at the bottom of the unit, that will reset the Ethernet adaptor.



3500 Door Access Control System Configurations

The 3500 door access control system firmware decodes 26-bit Wiegand, 30 Bit Rio Systems, 35 Bit HID corporate 1000, RBH 50 Bit cards currently, but Highpower Security plans on adding custom format support features in to the 3500 in the future. We will modify firmware currently to accommodate your card format. Because the Ethernet adaptor in the device is manufactured by Lantronix, diagnostic and setup software from Lantronix is fully compatible, and can be used to set up the IP address and other network settings. The adaptor also has integrated telnet and web interfaces for setup. You can run the door access control system in either TCP/IP or UDP modes with this adaptor, although the Highpower HMS software required TCP/IP operation.

More on the 3500 Door Access Control Software
Back to 3500 Door Access Control System Overview
View All Door Control System Models



Request a Quote









 

Copyright 2014 Highpower Security Products, LLC 290 Pratt St Meriden, CT sales@highpowersecurity.com